Ceiling is not uniformity
Reaching a displayed maximum does not prove that a loaded spool is heated evenly throughout the chamber.
← All dryers
Is this the right dryer for you?
Creality Space Pi Plus
Original Space Pi Plus: two-spool chamber with four filament outlets, adjustable 45–70°C control, and a 0–48 hour timer. This record does not cover V2 Plus.
Choose this if: You regularly prepare two spools that can share a cycle within 45–70°C.
The two-spool chamber lets you prepare both together, with four outlets to help route filament to your printers. It is a capacity choice, not a hotter alternative to the single-spool Space Pi.
2 spoolsfeed-through documented
Two spools, one temperature decision
- Check both spools
Confirm physical fit and the heat limit of each spool.
- Use a shared cycle
Both spools share one temperature. A second spool position is not an independent zone.
- Route the outlets
Check that both filament paths feed freely without sharp bends or excessive drag.
Two spools of the same PETG formulation may share its cited 60°C cycle on paper. Pairing a spool that requires 60°C with one that requires 100°C is a different job: this 70°C dryer cannot satisfy the higher requirement.
Compare dryers for the 60°C PETG reference →Temperature-ceiling screen
Family references this model can reach on paper
The spool also has a limit
Do not expose a spool to more heat than its maker permits. Respooling may be required for higher-temperature drying.
Exact product data wins
Formulation-specific instructions override this family-level screen. Confirm the exact model and current regional product specification.